|
|
|
|
Patent 
Chapter in Book 
Collaboration (Company, National Project) 
Press Release 
Oral Presentations
[2. Publications]
Paper, & Journals These are the list of
full-refereed articles.
2) M.Awano, K.Kani, Y.Takao and H.Takagi, Synthesis of Y-Ba-Cu-O Ultrafine Powders by Spray Drying and Subsequent Calcination under Low Pressure, Jpn. Jour. Appl. Phys., 30, L806-808 (1991).
3) Y.Takao, M.Awano and H.Takagi, A Successful Control Processing for Composite Particles of Oxide Superconductor, Trans. Advances in Superconductivity, 3rd, 745-748 (1991).
4) Y.Takao and K.Sakaguchi, Studies on the Traction Coefficient in Partial Electrohydrodynamic Lubrication, Trans.Jpn.Soc.Mech., 57, 2052-2057 (1991).
5) M.Awano, K.Kani, Y.Takao and H.Takagi, Synthesis of Oxide Superconductor by the Crystallization of the Amorphous Precursor Gel Prepared by the Sol-Gel Method, Trans. Science and Technology of New Glasses, 293-298 (1991).
6) M.Awano, Y.Takao, K.Kani and H.Takagi, Preparation of Ultrafine Powder and Thick Film of Oxide Superconductor by the Thermal Plasma Method, Trans. Ceramic Powder Processing Sci., 4, (1991).
7) Y.Takao, M.Awano and H.Takagi, Preparation and properties of Ag-YBa2Cu3O7-x Composite by Mist Pyrolysis, Trans. Ceramic Powder Processing Sci., 4, 585-590 (1991).
8) M.Awano, K.Kani, Y.Takao, Y.Kuwahara and H.Takagi, Mechanochemical Effects on Syonthesis and Sintering of Oxide Superconductor, Proc. Japan-Russia Synpo. Mechachemistry, 4, 741-746 (1992).
9) M.Awano, K.Kani, Y.Takao and H.Takagi, Synthesis of Composite Polycrystalline Ba2YCu3O7-x Superconductor by the SolGel Method, J. Ceram. Soc. Jpn, 100, 434-438 (1992).
10) Y.Takao, M.Awano and H.Takagi, Synthesis and properties of Ag-YBa2Cu3O7-X composite superconductor by mist-pyrolysis method, J. Ceram. Soc. Jpn, 100, 1206-1210 (1992).
11) Y.Takao, M.Awano and H.Takagi, Synthesis of YBa2Cu3O7-X composite superconductor by the spray drying method, J. Mater. Res., 7, 2942-2947(1992).
12) M.Awano, Y.Takao, K.Kani and H.Takagi, Synthesis and Properties of Powdered Oxide Superconductor by the Mist Pyrolysis Method, J. Chem. Engineer. Jpn., 25, 508-514 (1992).
13) M.Awano, K.Kani, Y.Takao and Y.Kuwahara, Mechanochemical effects on synthesis and pulverization of Ba2YCu3O7-X Superconductor and Ba2YCu3O7-X -Ag Composite, J. Mater. Res., 7, 3185-3193 (1992).
14) Y.Takao, M.Awano and H.Takagi, Composite YBa2Cu3O7-X Superconductor prepared by Spray Drying Method, Trans. Advances in Superconductivity, 5, 669-672 (1993).
15) Y.Takao, M.Awano, Y.Kuwahara and Y.Murase, Preparation of a multilayer and a compositional gradient layer composite by the aerosol filtration method, J. Mater. Res., 9, 2128-2132 (1994).
16) Y.Takao, M.Awano and H.Takagi, Preparation and properties of Ba2YCu3O7-X–BaZrO3 superconductive composite by spray drying method. J. Ceram. Soc. Jpn., 102, 237- 240 (1994).
17) M.Awano, Y.Kodama, K.Kato and Y.Takao, Microstructure Control of Oxide Superconductor by the Chemical Reaction and the Grain Growth Technique, Physica C, 235, 413-414 (1994).
18) M.Awano, Y.Kodama, Y.Takao and F.Wakai, Synthesis of the Polycrystalline Body of Ba2YCu3O7-x Superconductor Consists of Submicron Grains for the Superplastic Processing, Trans. MRS Japan, 16, 1049-1052 (1994).
19) M.Awano, Y.Takao, Y.Murase ,Y.Kuwahara and Y.Kodama, Microstructure Control of an Oxide Superconductor by a Hybridization Process through Grinding, Trans. Advances in Superconductivity, 7, 233-244 (1995).
20) Y.Takao, M.Awano, Y.Kuwahara and Y.Murase, Preparation of an oxide superconducting composite using aerosol process technology, J. Soc. Powder Technol., Jpn., 32, 144-150 (1995).
21) M.Awano, Y.Takao, Y.Murase, Y.Kuwahara and Y.Kodama, Microstructure Control of an Oxide Superconductor by a Hybridization Process through Grinding, J. Soc. Powder Technol., Jpn., 32, 158-163 (1995).
22) M.Awano, Y.Takao and Y.Kuwahara, Microstructure Control of an Oxide Superconductor by a Hybridization Process through Grinding, Advanced Powder Technol., 7, 233-244 (1995).
23) Y.Takao, Microstructure control of an oxide superconducting composite, Report of National Industrial Research Institute of Nagoya, 44, No.9, 445-455 (1995).
24) Y.Takao, M.Awano, Y.Kuwahara and Y.Murase, Preparation of oxide superconductive composite by an electrostatic mixing process, Sensors and Actuators B, 31, 131-133 (1996).
25) Y.Takao, M.Awano and Y.Kuwahara, Preparation of Properties of Composite Particles by Electrostatic Process, Proc. 5th World Congress of Chemical Engineering, 5, 543-548 (1996).
26) Y.Takao, M.Awano and Y.Kuwahara, Preparation and evaluation of aerosol composite particles by electrostatic process, J. Aerosol Sci., 27, S217-218(1996).
27) Y.Takao, M.Awano, Y.Kuwahara and Y.Murase, Preparation of a oxide superconducting composite using aerosol process technology, KONA, 14, 168-175 (1996).
28) Y.Takao, M.Awano and Y.Kuwahara, Preparation of Tin Dioxide-Palladium Aerosol Composite Particles by Electrostatic Adhesion Process, Proc. American Association for Aerosol Research 16th Annual Conference, 16, (1997).
29) M.Awano, Y.Takao and Y.Kuwahara, Microstructure Control of an Oxide Superconductor by a Hybridization Process through Grinding, Solid State Ionics, 101-103, 111-117 (1997).
30) Y.Takao, M.Awano and Y.Kuwahara, Preparation of composite particles of bulk Ba2YCu3O7-X by electrostatic adhesion process, AIChE J., 43, 2616-2623 (1997).
31) Y.Takao, Study on preparation and properties of composite particle and film by aerosol process, Doctoral Thesis of Osaka Prefecture University (1997).
32) M.Awano, Y.Takao, Y.Murase, Y.Kuwahara, O.Abe, Study on Multilayered Materials, Report of National Industrial Research Institute of Nagoya, 46, 305-332 (1997).
33) Y.Takao, M.Awano and M.Sando, SnO2 multilayered gas sensor with high selectivity prepared by an aerosol electrostatic process, Advanced Powder Technol., 9, 293-316(1998).
34) Y.Takao, M.Awano, M.Sando and Y.Kuwahara, Preparation and Properties of Aerosol Composite Particles by Electrostatic Adhesion Process, Proc. World Congress on Particle Technology, 3rd, (1998).
35) M.Naito, T.Hotta, Y.Takao, N.Shinohara, M.Okumiya and K.Uematsu, New Techniques for Characterization of Powder Properties for Improving Ceramic Properties, Proc. Fine Powder Processing 99, (1999).
36) Y.Takao, T.Hotta, K.Nakahira, M.Naito, N.Shinohara, M.Okumiya and K.Uematsu, Processing defects and their relevance to strength in alumina ceramics made by slip casting, J. Euro. Cera. Soc., 20, 389-395 (2000).
37) Y.Takao and M.Naito, Particle aggregated structure in silica particle filled epoxy resin composite system, J. Chem. Eng. Japan, 33, 317-322 (2000).
38) Y.Takao, H.Morikawa, Y.Murase, A.Tsuge, Y.Uwamino, M.Sando, Multilayered gas sensor and chemical evaluation technique via particulate structural control, Report of National Industrial Research Institute of Nagoya, 49, 169-184 (2000).
39) Y.Takao, M.Naito and H.Kamiya, Particulate structural contribution to viscosity of silica particle filled epoxy resin composite system, Advanced Powder Technol. 12, 17 (2001).
40) Y.Takao, M.Naito, T.Tatsumi and T.Sakurai, Particulate structural contribution to viscosity of aluminum nitride (AlN) particle filled epoxy resin composite system, Trans. Ceramic Powder Processing Sci., 7, in press.
41) Y.Takao and M.Sando; Flame Synthesis of Aluminum Nitride Filler-powder, J. Chem. Eng. Japan, in press.
